Yamaha 006IPTO-F0 Owner's Manual page 279

• xxx UNLATCH .............The assigned button function is enabled only while the incom-
• xxx ON...........................The corresponding channels are turned on or off each time the
• xxx ON UNLATCH......The corresponding channels are turned on only while the
• UDEFxxx.......................Same as the corresponding User Defined buttons.
■ Trigger sources available in the OUTPUT section
No Assign
CH1 FADER ON
:
CH48 FADER ON
BUS1 FADER ON
:
BUS8 FADER ON
AUX1 FADER ON
:
AUX8 FADER ON
ST FADER ON
CH1 FADER OFF
:
CH48 FADER OFF
BUS1 FADER OFF
:
BUS8 FADER OFF
AUX1 FADER OFF
:
AUX8 FADER OFF
• xxx FADER ON ............The trigger signal is transmitted when you raise a fader from
• xxx FADER OFF...........The trigger signal is transmitted when you lower a fader to –∞.
• xxx FADER TALLY.......The trigger signal is transmitted while a fader remains above
• xxx LATCH ...................Pressing the corresponding button toggles the trigger signal on
• xxx UNLATCH .............The trigger signal is transmitted while you are pressing and
• REC LAMP....................The trigger signal is transmitted while the transport section on
• POWER ON ..................The trigger signal is transmitted while the power to the
Using GPI (General Purpose Interface)
ing trigger signal is active.
incoming trigger signal becomes active.
incoming trigger signal is active.
ST FADER OFF
CH1 FADER TALLY
:
CH48 FADER TALLY
BUS1 FADER TALLY
:
BUS8 FADER TALLY
AUX1 FADER TALLY
:
AUX8 FADER TALLY
ST FADER TALLY
UDEF1 LATCH
:
UDEF12 LATCH
UDEF1 UNLATCH
:
UDEF12 UNLATCH
REC LAMP
POWER ON
–∞.
–∞.
and off.
holding down the corresponding button.
the Remote | Machine Control page is in record mode.
DM1000 is on.
279
DM1000 Version 2—Owner's Manual
20