Preparation For Seasonal Storage; Identification And Ordering; Model And Serial Number - Toro REELMASTER 3100-D Operator's Manual

8. When backlap operation is completed, stop the
engine, turn the backlap knob to the MOW position,
set the reel speed controls to the desired mowing
setting and wash all lapping compound off the
cutting units.
NOTE: Additional instructions and procedures on
Backlapping are available in the TORO Sharpening Reel
& Rotary Mowers Manual Form No. 80-300SL.
NOTE: For a better cutting edge, run a file across the
front face of the bedknife when the lapping operation is
completed. This will remove any burrs or rough edges
that may have built up on the cutting edge.
PREPARATION FOR SEASONAL
STORAGE
Traction Unit
1. Thoroughly clean the traction unit, cutting units and
the engine.
2. Check the tire pressure. Inflate all tires to 97–124
kPa.
3. Check all fasteners for looseness; tighten as
necessary.
4. Grease or oil all grease fittings and pivot points.
Wipe up any excess lubricant.
5. Cover the entire length of the Sidewinder (Model
03201) cross tube with a light oil to prevent rust.
After storage, wipe off all oil.
6. Lightly sand and use touch-up paint on painted
areas that are scratched, chipped, or rusted. Repair
any dents in the metal body.
7. Service the battery and cables as follows:
A. Remove the battery terminals from the battery
posts.
B. Clean the battery, terminals, and posts with a
wire brush and baking soda solution.
C. Coat the cable terminals and battery posts with
Grafo 112X skin-over grease (Toro Part No.
505-47) or petroleum jelly to prevent
corrosion.
D. Slowly recharge the battery every 60 days for
24 hours to prevent lead sulfation of the
battery.
Engine
1. Drain the engine oil from the oil pan and replace
the drain plug.
2. Remove and discard the oil filter. Install a new oil
filter.
3. Refill the oil pan with approximately 3.8 L of SAE
l0W-30 motor oil.
4. Start the engine and run at idle speed for
approximately two minutes.
5. Stop the engine.
6. Thoroughly drain all fuel from the fuel tank, lines
fuel filter and water separator assembly.
7. Flush the fuel tank with fresh, clean diesel fuel.
8. Secure all fuel system fittings.
9. Thoroughly clean and service the air cleaner
assembly.
10. Seal the air cleaner inlet and the exhaust outlet with
weatherproof tape.
11. Check anti-freeze protection and add as needed for
expected minimum temperature in your area.

IDENTIFICATION AND ORDERING

MODEL AND SERIAL NUMBER

The mower has two identification numbers: a model
number and a serial number. The two numbers are
stamped into a plate that is riveted to the frame of
mower. In any correspondence concerning the mower,
supply the model and serial numbers to ensure that
Maintenance
33