Toro REELMASTER 3100-D Operator's Manual page 13

Controls
Traction Pedals (Fig. 7)—Depress the traction-forward
pedal to move forward. Depress the traction-reverse
pedal to move backward or to help stop the machine
when moving forward. Also, allow the pedal to move to
the neutral position to stop the machine.
Mow/Transport Slide (Fig. 7)—Using your heel, move
the slide to the left to transport the machine and to the
right to mow. The cutting units will only operate in the
mow position.
Note: Mow speed is set at the factory to 6 mph. It can
be increased or decreased by adjusting the speed stop
screw (Fig. 8)
1 . Forward traction pedal
2. Reverse traction pedal
3. Mow/Transport slide
4. Tilt steering lover
5. Indicator slot
1. Speed Stop Screw
Tilt Steering Lever (Fig. 7)—Pull the lever back to tilt
the steering wheel to the desired position. Then push the
4
1
2
5
3
Figure 7
1
Figure 8
lever forward to tighten the steering wheel position.
Starter Switch (Fig. 9)—The starter switch has three
positions: OFF, ON/PREHEAT and START Turn the key
to the ON/PREHEAT position until the glow plug
indicator light goes out (approximately 7 seconds), then
turn the key to the START position to engage the starter.
Release the key when the engine starts. The key will
move automatically to the ON/RUN position. To shut the
engine off, turn the key to the OFF position. Remove the
key from the switch to prevent accidental starting.
Throttle (Fig. 9)—Moving the throttle forward increases
engine speed; moving it rearward decreases engine
speed.
Cutting Unit Shift Lever (Fig. 9)—To lower the cutting
units to the ground, move the lift lever forward. The
cutting units will not drop unless the engine is running
and will not operate in the raised position. To raise the
cutting units, pull the lift lever rearward to the RAISE
position.
Model 03201 only: Move the lever to the right or left to
move the cutting units in the same direction. This should
only be done when the cutting units are raised or if
they're on the ground and the machine is moving.
Note: The lever does not have to be held in the forward
position while the cutting units are lowered.
Indicator Slot (Fig. 9)—The slot in the operator's
platform indicates when the cutting units are in the
center position.
Cutting Unit Drive Switch (Fig. 9): The switch has two
positions: ENGAGE and DISENGAGE. A rocker switch
operates a solenoid valve to drive the cutting units.
13