Adjusting The Throttle - Toro REELMASTER 3100-D Operator's Manual

Maintenance
1
Figure 37
1. Alternator/tan Belt
Hydrostat Drive Belt Replacement (Fig. 38)
1. Insert a nut driver or small piece of tubing onto the
end of the belt-tensioning spring.
Use caution when releasing spring tension—it is
under a heavy load.
2. Push down and forward on the spring end to
unhook it from the bracket and release tension on
the spring.
3. Replace the belt.
4. Reverse the procedure to tension the spring.
Figure 38
1. Hydrostat Drive Belt
2. Spring end
28
WARNING
2
1

ADJUSTING THE THROTTLE

(Fig. 39)
1. Position the throttle lever rearward so that it stops
against the control panel slot.
2. Loosen the throttle cable connector on the lever arm
at the injection pump.
Figure 39
1. Injection Pump Lever Arm
3. Hold the injection pump lever arm against the low-
idle stop and tighten the cable connector.
4. Loosen the screws securing the throttle control to
the control panel.
5. Push the throttle control lever all the way forward.
6. Slide the stop plate until it contacts the throttle lever
and tighten the screws securing the throttle control
to the control panel.
7. If the throttle does not stay in position during
operation, torque the lock nut used to set the friction
device on the throttle lever. The maximum force
required to operate the throttle lever should be 27
Nm.
CAUTION
Before servicing or making adjustments to the
machine, stop the engine and remove the key from the
switch.
1