Before Operating; Check Crankcase Oil - Toro REELMASTER 3100-D Operator's Manual

Before Operating

CAUTION
Before servicing or making adjustments to the
machine, stop the engine and remove the key from
the switch.

CHECK CRANKCASE OIL

(Fig. 1–2)
The engine is shipped with oil in the crankcase;
however, the oil level must be checked before and after
the engine is first started.
Crankcase capacity is 2.8 l with the filter.
1. Position the machine on a level surface.
2. Remove the dipstick and wipe it with a clean cloth.
Push the dipstick down into the dipstick tube and
make sure it seats fully. Pull the dipstick out and
check the oil level. If it is low, add enough oil to
raise the level to the FULL mark on the dipstick.
1. Dipstick
1. Oil fill cap
10
1
Figure 1
1
Figure 2
3. If the oil level is low, remove the oil fill cap and
gradually add small quantities of oil, checking the
level frequently, until the level reaches the FULL
mark on the dipstick.
4. The engine uses any high-quality 10W30 detergent
oil having the American Petroleum Institute—
API—"service classification" CD, CE, CF CF-4 or
CG-4.
5. Install the oil fill cap and close the hood.
IMPORTANT: Check the level of oil every 5
operating hours or daily. Change the oil after every
50 hours of operation.
FILL THE FUEL TANK (Fig. 3)
The engine runs on No. 2 diesel fuel. Fuel tank capacity
is approximately 28.4 L.
1. Clean the area around the fuel tank cap.
1
1. Fuel tank cap
2. Remove the fuel tank cap.
3. Fill the tank to bottom of the filler neck. DO NOT
OVERFILL. Then install the cap.
4. Wipe up any fuel that may have spilled to prevent a
fire hazard.
Figure 3