Toro REELMASTER 3100-D Operator's Manual page 26

Maintenance
separator (Fig. 32) daily,
1. Place a clean container under the fuel filter.
2. Loosen the drain plug on the bottom of the filter
canister. Tighten the plug after draining.
1
Figure 32
1. Water Separator
2. Drain Plug
Replace the filter canister after every 400 hours of
operation.
1. Clean the area where the filter canister mounts.
2. Remove the filter canister and clean the mounting
surface.
3. Lubricate the gasket on the filter canister with clean
oil.
Install the filter canister by hand until the gasket contacts
the mounting surface, then turn an additional 1/2 turn.
Replacing the fuel Pre Filter (Fig. 33).
Replace the fuel pre filter, located on the inside of the
frame rail below the water separator after every 400
operating hours or yearly, whichever occurs first.
1. Remove the screw securing the filter to the frame
rail.
2. Clamp both fuel lines that connect to the fuel filter
so fuel cannot drain when lines are removed.
3. Loosen the hose clamps at both ends of the filter
and pull the fuel lines off the filter.
26
2
Figure 33
1. Fuel Pre Filter
2. Hose Clamps
4. Slide the hose clamps onto the ends of the fuel
lines. Push the fuel lines onto the fuel filter and
secure them with hose clamps. Be sure the arrow on
the side of the filter points toward the injection
pump.
DANGER
Because diesel fuel is flammable, use caution when
storing or handling it. Do not smoke while filling the
fuel tank. Do not fill the fuel tank while the engine is
running, hot, or when the machine is in an enclosed
area. Always fill the fuel tank outdoors and wipe up
any spilled diesel fuel before starting the engine. Store
fuel in a clean, safety-approved container and keep the
cap in place. Use diesel fuel for the engine only; not
for any other purpose.
BLEEDING AIR FROM
INJECTORS (Fig. 34)
Note: This procedure should be used only if the fuel
system has been purged of air through normal priming
procedures and the engine will not start; refer to
Bleeding The Fuel System.
1. Loosen the pipe connection to the No. 1 nozzle and
holder assembly.