Register/Read/Delete Data For Initialization - Mitsubishi Electric MELSEC iQ-R Series User Manual

Register/read/delete data for initialization

The section explains the registration/reading/deletion of the data for initialization such as initialization commands for the
modem/TA connected to the C24 side for data communication with the target device using the modem function.
Details of the data for initialization
The following shows the registration destination and type of the data for initialization, registration number, and registration
count.
Up to 78 bytes of initialization commands can be registered as one data for initialization. (For 78 characters)
Registration destination of
data for initialization
CPU module Built-in memory
SD memory card
C24 Flash ROM
Buffer memory
*1 For the priority of the registered data, refer to the following section.
Page 401 PARAMETER REGISTRATION TO CPU MODULE
Considerations for registration of data for initialization
• Do not include CR/LF (data code : 0DH/0AH) in the data for initialization to be registered to C24.
The CR/LF is output at the end of the AT command by C24 at the time of the initialization processing (automatically added).
• The registration status of the data for initialization stored in the flash ROM may be checked in the buffer memory (Un\G550
to 552).
For initial registration, register by designating an unregistered number.
When designating a registration number that has already been registered, first delete the registration data for the
designated number prior to registration.
Types of data for Registration number of
initialization that is data for initialization
registered
Arbitrary data for 2500 to 2529 (9C4H to 9E1H)
initialization registered by
*1
the user
Arbitrary data for 2500 to 2529 (9C4H to 9E1H)
initialization registered by
*1
the user
Data for initialization that 2000 to 2013 (7D0H to 7DDH)
is registered before
shipment
Arbitrary data for 2500 to 2529 (9C4H to 9E1H)
initialization registered by
*1
the user
Arbitrary data for –32767 to –32737 (8001H to
initialization registered by 801FH)
the user
Number of Remarks
registrations
30 • Register the data for initialization
after the debug process has been
completed.
• By registering data in this area,
replacing C24 can be performed
easily.
30 • Register the data for initialization
after the debug process has been
completed.
• By registering data in this area,
replacing C24 can be performed
easily.
• Page 178 Registration contents
13
before shipment
30 • Register the data for initialization
after the debug process has been
completed.
31 • Register the data for initialization
before the debug process has been
completed.
7 COMMUNICATIONS BY THE MODEM FUNCTION
7.4 Startup of the Modem Function
7
177