Table of Contents
Advertisement
Figure 15
1. Plug
3.
Loosen the jam nut on each tow valve.
Figure 16
1. Tow valve
4.
Turn each valve counterclockwise 1 turn with a
hex wrench to open them.
5.
Tow the machine as required.
Important:
Do not exceed 4.8 km/h (3 mph)
when towing.
6.
After repairing the machine, close the tow valves
and tighten the jam nuts.
Important:
valves.
7.
Replace the plugs.
Hauling the Machine
Use a heavy-duty trailer or truck to haul the machine.
Use a full-width ramp. Ensure that the trailer or truck
has all the necessary brakes, lighting, and marking as
required by law. Please carefully read all the safety
instructions. Knowing this information could help
you or bystanders avoid injury. Refer to your local
ordinances for trailer and tie-down requirements.
WARNING
Driving on the street or roadway without
turn signals, lights, reflective markings, or a
slow-moving-vehicle emblem is dangerous
and can lead to accidents causing personal
injury.
g304099
Do not drive the machine on a public street
or roadway.
Selecting a Trailer
WARNING
Loading a machine onto a trailer or truck
increases the possibility of tip-over and could
cause serious injury or death
• Use only full-width ramps.
• Ensure that the length of ramp is at least 4
times as long as the height of the trailer or
truck bed to the ground. This ensures that
ramp angle does not exceed 15 degrees on
flat ground.
g304100
21
Do not overtighten the tow
(Figure
17).
Hide quick links:
Advertisement
Table of Contents
