Using The Infocenter - Toro e-Dingo 500 Operator's Manual

Removing an Attachment
1. Park the machine on a level surface.
2. Lower the attachment to the ground.
3. Shut off the machine and remove the key.
4. Disengage the quick-attach pins by turning them
to the outside.
5. If the attachment uses hydraulics, move the
auxiliary-hydraulics lever forward, backward,
and back to the N
pressure at the hydraulic couplers.
6. If the attachment uses hydraulics, slide the
collars back on the hydraulic couplers and
disconnect them.
Important:
Connect the attachment hoses
together to prevent hydraulic system
contamination during storage.
7. Install the protective covers onto the hydraulic
couplers on the machine.
8. Start the machine, tilt the mount plate forward,
and back the machine away from the attachment.

Using the InfoCenter

Changing the Attachment Mode
1. From the Run screen, press the middle button to
access the Attachment Change screen.
2. Press the middle or right button to switch
between Hammer or Bucket mode.
Note:
Turn on Eco mode when using Hammer
mode. Hammer Mode
mode, slows the motor speed (in rpm) to reduce
energy consumption when using attachments.
Bucket Mode
3. Press the left button to return to the Run screen.
Figure 12
1. Current attachment mode
2. Change attachment mode
position to relieve
EUTRAL
, when used with Eco
maintains the motor speed.
3. Return to Run screen
Accessing Protected Menus
Note:
The factory default PIN code for you machine
is either 0000 or 1234.
If you changed the PIN code and forgot the code,
contact your Authorized Service Dealer for assistance.
1. From the M
scroll down to the S
right button
2. In the S
ETTINGS
scroll down to the P
the right button
3. To enter the PIN code, press the center button
until the correct first digit appears, then press
g304809
the right button to move on to the next digit
(Figure 14B and
until the last digit is entered and press the right
button once more.
4. Press the middle button to enter the PIN code
(Figure 14D).
18
M , use the center button to
AIN ENU
M
ETTINGS ENU
(Figure 13).
Figure 13
M , use the center button to
ENU
M
ROTECTED ENU
(Figure 14A).
Figure 14
Figure 14C). Repeat this step
and press the
g264775
and press
g264249