Table of Contents
Advertisement
Starting the Machine
1.
Stand on the platform.
2.
Ensure that the parking brake is engaged and all
4 levers are in the N
3.
Insert the key into the key switch and turn it to
the O
position.
N
Note:
The machine may have difficulty starting under
severe cold conditions. When starting a cold machine,
keep the machine above -18°C (0°F).
Note:
When the machine temperature is below -1°C
(30°F), the cold-start symbol
on the InfoCenter while the motor increases speed
for 2 minutes. During this time, do not move the
traction controls while the parking brake is engaged;
otherwise, the motor shuts off and the 2 minutes
resets. The cold-start symbol disappears when the
motor reaches full speed.
Driving the Machine
Use the traction controls to move the machine. The
farther you move the traction controls in any direction,
the faster the machine moves in that direction.
Release the traction controls to stop the machine.
position.
EUTRAL
(Figure
9) will appear
Figure 9
Shutting Off the Machine
1.
Park the machine on a level surface, lower the
loader arms, and engage the parking brake.
2.
Ensure that the auxiliary hydraulics lever is in
the N
EUTRAL
3.
Turn the key switch to the O
remove the key.
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while
it is unattended.
Always remove the key and engage the
parking brake when leaving the machine
unattended.
Using Attachments
Installing an Attachment
g304012
Important:
Use only Toro-approved attachments.
Attachments can change the stability and the
operating characteristics of the machine. The
warranty of the machine may be voided if you use
the machine with unapproved attachments.
Important:
Before installing the attachment,
ensure that the mount plates are free of any dirt or
debris and that the pins rotate freely. If the pins
do not rotate freely, grease them.
1.
Position the attachment on a level surface with
enough space behind it to accommodate the
machine.
2.
Start the machine.
3.
Tilt the attachment mount plate forward.
4.
Position the mount plate into the upper lip of the
attachment receiver plate
1. Mount plate
16
position.
position and
FF
(Figure
10).
Figure 10
2. Receiver plate
g003710
Hide quick links:
Advertisement
Table of Contents
