Toro e-Dingo 500 Operator's Manual page 25

Connecting to a Power Source
To reduce the risk of electric shock, this charger has a
3-prong grounded plug (type B). If the plug does not
fit into the wall receptacle, other grounded plug types
are available; contact an Authorized Toro Dealer.
Do not change the charger or the power-supply-cord
plug in any way.
DANGER
Contact with water while charging the
machine could cause electric shock, causing
injury or death.
Do not handle the plug or the charger with wet
hands or while standing in water.
Important:
Check the power supply cord
periodically for holes or cracks in the insulation.
Do not use a damaged cord. Do not run the cord
through standing water or wet grass.
1. Insert the charger plug on the power-supply
cord into the matching input power socket on
the charger.
WARNING
A damaged charger cord can cause an
electrical shock or a fire.
Thoroughly inspect the power supply
cord before using the charger. If the cord
is damaged, do not operate the charger
until you obtain a replacement.
2. Insert the wall plug end of the power supply cord
into a grounded electrical outlet.
Charging the Batteries
Important:
Charge the batteries only in
temperatures that are within the recommended
range; refer to the following table for the
recommended range:
Recommended Temperature Range for
Charging
Charging range
Low-temperature charging
range (Reduced Current)
High-temperature charging
range (Reduced Current)
If the temperature is below -5°C (23°F), the batteries
will not charge. If the temperature rises above -5°C
(23°F), unplug the charger and plug it in again to
charge the batteries.
0° to 45°C (32° to 113°F)
-5° to 0°C (23° to 32°F)
45° to 60°C (113° to 140°F)
1. Park the machine in the designated location for
charging.
2. Engage the parking brake.
3. Shut off the machine and remove the key.
4. Ensure that the connectors are free of dust and
debris.
5. Connect the charger power cord to a power
source; refer to
(page 25).
6. Slide the charger cover up and pivot it out of the
way (Figure 23).
1. Charger cover
7. Plug the charger-output connector into the
charger connector on the machine.
25
Connecting to a Power Source
Figure 23
g304908