Sony FVS-1000 Series Operation Manual page 32

Menu Operations
Item
VIDEO LIFT/GAIN
VIDEO LIFT
VIDEO GAIN
IMAGE ENHANCER
SOURCE RGB
LEVEL DEPENDENT
H PEAK FREQ
V PEAK FREQ
H/V MIX RATIO
DETAIL GAIN
CRISPENING
SKINTONE
ON
SEL
30
Setting(s)
Adjust the black level of the video.
R (red): Adjust the black level of red.
G (green): Adjust the black level of green.
B (blue): Adjust the black level of blue.
Adjust the white level of the video.
R (red): Adjust the white level of red.
G (green): Adjust the white level of green.
B (blue): Adjust the white level of blue.
Image enhancing function
Adjust the ratio to extract the edge component from R (red),
G (green), and G (blue). Select the output from among HD,
SD1, and SD2.
Adjust the ratio of red with the second control knob from the
left.
Adjust the ratio of blue with the rightmost control knob.
When the EXECUTE button is pressed, the ratio extracted from
the Y component is adjusted.
Adjust the level of the effective range of the enhancer.
Select an output from among HD, SD1, and SD2.
LOW: Adjust the lowest level of the range using the leftmost
control knob.
HIGH: Adjust the highest level of the range using the second
leftmost control knob
Adjust the effective range of the enhancer for the H peak
frequency.
Select an output from among HD, SD1, and SD2.
LOW/MID/HIGH: Adjust the point using the three leftmost
control knobs.
Adjust the effective range of the enhancer for the V peak
frequency.
Select an output from among HD, SD1, and SD2.
LOW/HIGH: Adjust the point using the two leftmost control
knobs.
Adjust the ratio to add enhancement horizontally and vertically.
Select the output from among HD, SD1, and SD2.
Adjust the vertical ratio with the leftmost control knob.
Adjust the detail gain.
Select an output from among HD, SD1, and SD2.
M (MASTER): Adjust the detail gain of master using the
leftmost control knob.
Adjust the crispening and coring.
Select an output from among HD, SD1, and SD2.
LOW: Adjust the low-level threshold of the edge component
using the leftmost control knob (coring).
HIGH: Adjust the high-level threshold of the edge component
using the second leftmost control knob (crispening).
Adjust the amount of enhancement according to the color area.
Select the output from among HD, SD1, and SD2.
Enable this function. (The EXECUTE button lights.)
GAIN: Adjust the gain with the leftmost control knob.
Select the area where this function is to be enabled. (The
SOURCE button lights, and the selected area is shown with
black-and-white hatchmarked pattern.)
HUE: Adjust the HUE with the leftmost control knob.
AREA: Adjust the AREA (0° to 120°) with the second control
knob from the left.
Mode Operation
No. No.
28 2 9 0
29 2 9 0
41 2 3 4
9 0
42
2 3 8
9 0
43 2 3 9 0
44 2 3 9 0
45
2 3 9 0
46
47 2 3 9 0
48 2 3 8
9 0
48 2 3 4
48 2 3 5 8