Sony FVS-1000 Series Operation Manual page 18

Film Loading
7
Mount the new lens aligning the positioning pin,
then turn the mount lever in the opposite direction
of the arrow in step 6 to fasten the lens.
8
Connect the lens connector.
9
Push in the camera block.
10
Lock the camera block with the two lock levers.
11
Close the rear door.
To change the gate assembly
Note
Before changing the gate assembly, be sure to turn off
the power by setting the power switch to the a side.
1
Remove the OPS cover by pulling it out.
16
OPS cover
2
Loosen the two fixing screws by turning them
counterclockwise 90 degrees.
Fixing screws
3
Remove the retainer assembly by pulling it out.
4
Loosen the two fixing screws by turning them
counterclockwise 90 degrees.
Gate assembly
5
Remove the gate assembly by pulling it out.
6
Attach the new retainer assembly and gate
assembly for the 35-mm or 16-mm film, then
secure the fixing screws.
7
Replace the OPS cover.
Retainer assembly
Fixing screws