Antenna Settings - Siemens SCALANCE W780 Configuration Manual

Configuring with Web Based Management
5.3 "Wizard" menu
● "SNMP" drop-down list:
Select the protocol from the drop-down list. The following settings are possible:
– "-" (SNMP disabled)
– SNMPv1/v2c/v3
– SNMPv3
● "SNMPv1/v2 Read-Only" check box
Enable or disable write access to SNMP variables with SNMPv1/v2c.
● "SINEMA Configuration Interface" check box
If the SINEMA configuration interface is enabled, you can download configurations to the
device via the TIA Portal.
5.3.1.5

Antenna Settings

Introduction
On this Basic Wizard page, you configure the settings for the external antenna.
70
Access to device parameters via SNMP is not possible.
Access to device parameters is possible with SNMP versions 1, 2c or 3. You can
configure other settings in "System > SNMP > General".
Access to device parameters is possible with SNMP version 3. You can configure
other settings in "System > SNMP > General".
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
Configuration Manual, 03/2015, C79000-G8976-C267-08