Cist Port - Siemens SCALANCE W780 Configuration Manual

reconfiguration of the network will be triggered whenever a link to this port is modified.
The L2T clients should be interconnected.
●
Select this check box if you want to detect automatically whether or not an end device is
connected at all layer 2 tunnel ports.
Procedure
1. Enter the data required for the configuration in the input boxes.
2. Click the "Set Values" button.
5.7.3.3

CIST port

MSTP-CIST port configuration
When the page is called, the table displays the current status of the configuration of the port
parameters.
To configure them, click the relevant cells in the port table.
Description
Table 1 has the following columns:
● Column 1
Shows that the settings made in this table will be adopted for all ports of table 2 after
clicking the "Copy to Table" button.
● Spanning Tree Status
In the drop-down list, select the setting for all ports. If "No Change" is selected, the entries
of the corresponding column in table 2 remain unchanged.
● Copy to Table
If you click the button, the settings are adopted for all ports of table 2.
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
Configuration Manual, 03/2015, C79000-G8976-C267-08
"Layer-2 Tunnel Auto Edge Port" check box (available only in access point mode)
Configuring with Web Based Management
5.7 "Layer 2" menu
255