Appendix D
D.1
Messages in the event log
Messages during system startup (general)
Alarm
Warm start performed, Ver: V02.00.00 -
event/status summary after startup
Power supply:
L1 is connected
•
L2 is not connected
•
No line is monitored
MSTP disabled
MSTP enabled
No Fault states pending after startup
Status of the power supply
Alarm
Power up on line 1 / 2 / PoE.
Power down on line 1 / 2 / PoE.
Status of the Ethernet interface
Alarm
Link up on P1.
Link down on P1.
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
Configuration Manual, 03/2015, C79000-G8976-C267-08
Description
Type of startup and the loaded firmware version.
Status of the power supplies line 1 and line 2.
Information about monitoring the power supply from the signaling sys-
tem.
Information on the status of the Spanning Tree protocol.
Fault state following system start.
Description
You enable or disable the "Power Change" event in "System > Events".
Power supply exists on line 1, line 2 or PoE..
Power supply interrupted on line 1, line 2 or PoE.
Description
You enable or disable the "Link Change" event in "System > Events".
A connection exists on the Ethernet interface.
No connection exists on the Ethernet interface.
D
309