Siemens SCALANCE W1780 Configuration Manual page 221

Description
The table has the following rows:
● Port
Select the port to be configured from the drop-down list.
● State
Specify whether the port is enabled or disabled.
– enabled
– disabled
● Port name
Enter a name for the port.
● MAC Address
Shows the MAC address of the port.
● Mode Type
Select the transmission speed and the transmission method of the port from this drop-down
list. The transmission speed can be 10 Mbps, 100 Mbps or 1000 Mbps. As the transmission
mode, you can configure full duplex (FD) or half duplex (HD). If you set the mode to "Auto
negotiation", these parameters are automatically negotiated with the connected end device.
This must also be in the "Auto negotiation" mode for this purpose.
Note
Before the port and partner port can communicate with each other, the settings must match
at both ends.
Note
If 10 Mbps is configured as the transmission speed or half duplex (HD) as the transmission
mode, this can lead to restrictions in PROFINET communication. Always select at least 100
Mbps and full duplex (FD) or "Auto negotiation" if you want the device to handle PROFINET
communication.
● Mode
Shows the transmission speed and the transmission method of the port.
● Negotiation
Shows whether the automatic configuration of the connection to the partner port is enabled
or disabled.
SCALANCE W1780/W1740 according to IEEE 802.11ac Web Based Management
Configuration Manual, 11/2019, C79000-G8976-C485-03
The port is enabled. Data traffic is possible only over an enabled port.
The port is disabled.
Configuring with Web Based Management
6.6 "Interfaces" menu
221