Toro Greensmaster 3250-D Operator's Manual page 48

Figure 54
1. Knob (reel-speed control)
2. Handle (backlap lever)
5. Rotate the reel-speed knob to setting 1
54).
6. Start the engine and run at low idle speed.
Important:
Do not change the engine speed
while backlapping or the reels may stall.
Only backlap at idle engine speed.
7. With the mow/transport lever in the N
position, move the raise/lower mow control
forward to start the backlapping operation on the
reel.
8. Apply lapping compound with a long-handled
brush. Never use a short-handled brush.
•
If the reels stall or become erratic while
backlapping, select a higher reel speed
setting until the speed stabilizes, then return
the reel speed to setting 1 or to your desired
speed.
•
To make an adjustment to the cutting units
while backlapping, turn the reels off by
moving the raise/lower mow control rearward
and shut off the engine. After completing
adjustments, repeat steps
9. Repeat the steps
that you want to backlap.
3. R position
4. F position
EUTRAL
4 through 8.
4 through 8 for all cutting units
10. When finished, return the backlap lever to the
F position, move the reel speed knob to the
desired reel-speed setting, lower the seat, and
wash all lapping compound off of the cutting
units. Adjust cutting unit reel to bedknife as
needed.
Important:
lever to the F position after backlapping,
the cutting units will not raise or function
properly.
g229849
g229848
(Figure
48
If you do not return the backlap