Table of Contents
Advertisement
Commissioning
Setting timer for central lubrication system
4.3.2 Setting timer for central lubrication system
On delivery, the timer on the central lubrication system is set to lubricate in cyclic
intervals of 0.5–10 s and with an equivalent waiting time between lubrication. This
setting may need to be changed if too much lubricant is pumped out or if lubrication
is unsatisfactory.
Set the timer as follows:
1. Locate the central lubrication system.
2. Set the function using DIP switches 4
Function
Cyclic lubrication interval:
The lubrication valve opens for t
again for t
Inverted cyclic lubrication interval:
The same as above but with the difference that the cycle starts with the
valve closed, i.e. t
Switch-on impulse:
When the power is switched on, the lubrication valve opens for t
then closes for as long as the power is on.
Switch-on delay:
When the power is switched on, a delay is activated for t
lubrication valve opens. The valve remains open until the power is
turned off.
3. Set the interval for t
2-42
Action
The control panel is behind the small
hatch on the lubrication system at
position 1.
and 5 as shown in the table below.
, etc.
on
– t
– t
off
on
off
using DIP switches
on
1–3 and the interval for t
off
switches 6–8 as shown in the table below.
Info/Illustration
(see step 3), closes for t
on
, etc.
using DIP
1
3HEA 800 970-001 Rev. D, Mars 2006
1
4
5
DIP switch
and opens
off
and
on
before the
off
2
3
6
7
8
Advertisement
Chapters
Table of Contents
