4
Parts Replacement and Cleaning Procedure > Removing the Motors > Removing the Entrance Roller Release /Stopper HP Motor
Removing the Entrance Roller Release /Stopper HP Motor
1) Remove the harness from the harness guide.
2) Disconnect one relay connector.
3) Remove one screw and then the cover.
x1
6) Remove three resin rings, two pulleys, one gear, one belt, and three parallel pins.
4
Parts Replacement and Cleaning Procedure > Removing the Motors > Removing the Entrance Roller Release /Stopper HP Motor
4) Remove two reuse bands.
5) Remove two screws and then the cover.
F-4-70
F-4-70
7) Remove two screws and then the entrance roller release /stopper HP motor along with the
mount.
8) Remove two screws and then the entrance roller release /stopper HP motor.
F-4-72
F-4-72
x2
x2
x4
4-25
F-4-71
F-4-71
F-4-73
F-4-73
4-25