3
3-37 Calibrating from the Control Panel using AutoCal2
Removing calibration
It is also possible to remove calibration from the ColorPASS. In general, it is not
necessary because any new calibration replaces the existing one if the same calibration
set is selected.
T
O REMOVE CALIBRATION FROM THE
1. From the ColorPASS Control Panel, access the Calibration menu as described on
page 3-35.
2. Choose Remove Calibration.
3. When prompted, verify that you want to proceed with removing calibration.
The current measurements are removed and a default calibration is restored.
C
P
:
ONTROL
ANEL