ABB TZIDC Operating Instructions Manual page 39

TZIDC DIGITAL POSITIONER | OI/TZIDC-EN REV. B
Parameter Display Function
P8._ ANLG_OUT
P8.0 MIN_RGE Min. range
P8.1 MAX_RGE Max. range
P8.2 ACTION Action
P8.3 ALARM Alarm current
P8.4 RB_CHAR Readback character.
P8.5 TEST Test
P8.6 ALR_ENAB Alarm function enabled Alarm via analog output
P8.7 CLIPPING Current signal
Signal clipping range
P8.8 EXIT Return
P9._ DIG_OUT
P9.0 ALRM_LOG Alarm logic
P9.1 SW1_LOG Switchpoint 1 logic
P9.2 SW2_LOG Switchpoint 2 logic
P9.3 TEST Test
P9.4 EXIT Return
P10._ DIG_IN
P10.0 FUNCTION Function select
P10.1 EXIT Return
P11._ FS / IP
P11.0 FAIL_POS Save position
P11.1 FACT_SET Factory setting
P11.2 IP-TYP I/P module type
P11.3* IP_COMP IP compensation
P11.4 HART_REV HART revision
P11.5 EXIT Return
* Activation by ABB Service only
Note
For detailed information on the parameterization of the device, consult the associated configuration and parameterization
instructions.
Min. current range
Max. current range
Direction of action of
characteristic curve
Alarm message
Converted characters
Test
Extension of signal output to
3.8 to 20.5 mA
Return to operating level
Alarm output logic
Logic SW1
Logic SW2
Test
Return to operating level
Function selection
Return to operating level
Safe position
Factory setting
Type of l/P module
IP compensation
HART revision
Return to operating level
Possible parameter setting
4.0 to 18.4
20.0 to 5.7
DIRECT, REVERSE
HIGH_CUR, LOW_CUR
DIRECT, RECALC
Function
ON, OFF
4.0 to 20.0; 3.8 to 20.5 mA
Function
ACTIVE_HI, ACTIVE_LO
ACTIVE_HI, ACTIVE_LO
ACTIVE_HI, ACTIVE_LO
Function
Function
NONE, POS_0 %, POS_100 %, POS_HOLD
Function
ACTIVE, INACTIVE
Function
NO_F_POS,F_SAFE_1,F_SAFE_2,
F_FREEZE1, F_FREEZE2
ON, OFF
5; 7
Function
39
Unit Factory setting
mA 4.0
mA 20.0
--- DIRECT
--- HIGH_CUR
DIRECT
--- NONE
--- ON
mA 4.0 bis 20.5
--- ---
--- ACTIVE_HI
--- ACTIVE_HI
--- ACTIVE_HI
--- NONE
--- NV_SAVE
--- NONE
--- ---
--- INACTIVE
--- START
--- [CUSTOM]
--- ON
--- 5
--- NV_SAVE