Mounting On Linear Actuators - ABB PositionMaster EDP300 Operating Instruction

18 PositionMaster EDP300 DIGITAL POSITIONER | OI/EDP300-EN REV. D
... 7 Installation
... Mechanical mounting

Mounting on linear actuators

For mounting on a linear actuator in accordance with DIN / IEC
534 (lateral mounting as per NAMUR), the following attachment
kit is available:
9
8
7
j
k
l
m
1 Screw
2 Washer
3 Mounting bracket
4 Lever with follower pin for
mechanical stroke 10 to 35 mm
(0.39 to 1.38 in) or 20 to 100 mm
(0.79 to 3.94 in)
5 Washers
6 Screws
Figure 6: Components of attachment kit
1
2
3
5
6
4
M10413-01
7 U-bolts
8 Washers
9 Nuts
j Screws
k Spring washers
l Clamp plates
m Follower guide
1
2
3
4
Figure 7: Attaching a follower guide to the actuator
1. Tighten the screws so that they are hand-tight.
2. Attach the follower guide
screws and spring washers
4
3
1 2
7
6
Figure 8: Mounting lever and bracket on the positioner
1. Attach the lever to the feedback shaft
6
positioner (can only be mounted in one position due to the
cut shape of the feedback shaft).
2. Using the arrow marks
4
within the operating range (between the arrows).
3. Hand-tighten the screw
M10411-01
and clamp plates with
1 2
to the actuator stem.
3
5 4
of the
5
, check whether the lever moves
on the lever.
7
M10409-01