Mounting Orientation D (Optional Enclosure Extension Included); Fastening The Unit - ABB ACS800 Hardware Manual

66

Mounting orientation d (optional enclosure extension included)

The customer connections of the drive (power cable terminals, I/O terminal blocks,
option module slots) are provided in the enclosure extension instead of the actual
drive cubicle. The extension cubicle and the drive cubicle are fastened together at
the factory with two screws at the top of the cubicles. The drive pedestal is fastened
to the base plate of the enclosure extension.

Fastening the unit

See Dimensional drawings
Fasten the unit to the floor with four screws using the holes provided in the base
plate.
It is recommended to fasten the unit to the rear wall as well. Use the holes at the top
of the enclosure extension and at the top of the drive cubicle. The enclosure
extension is fastened as follows:
1. Remove the top lead-through plate.
2. Fasten the unit with screws or bolts to the holes in the wall.
3. Refasten the top lead-through plate.
Installation
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
2
for the locations of the fastening points.
1
2