ABB ACS800 Hardware Manual page 52

52
WARNING! The drive is heavy [frame size R7: 110 kg (220 lb), frame size R8:
240 kg (507 lb)]. Lift the drive by the upper part only using the lifting lugs attached to
the top of the unit. The lower part will be deformed from lifting. Do not remove the
pedestal before lifting.
Do not tilt the drive. The centre of gravity of the unit is high. The unit will overturn
from a tilt of about 6 degrees.
Do not wheel the drive except for installation (the front direction is preferable
because the front wheels are steadier). The drive frame may be deformed from
wheeling when the pedestal is removed. If the drive is moved over long distances,
place it on its back on a pallet and move it by fork-lift.
Do not lift by the lower
part of the frame.
Installation
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Do not tilt!
Back
Front
Do not wheel over
long distances.
Frame size R8:
The support legs must be locked to open
position during the installation and
always when wheeling the unit.