ABB ACS560 Hardware Manual page 70

70 Electrical installation
The bare shield will be grounded 360 degrees. Mark the pigtail made from the shield as a
PE conductor with yellow-and-green color
PE
PE
80 Electrical installation
5. Connect the input power cable as follows:
5. Connect the input power cable as follows:
• Connect the twisted shield of the cable to the grounding terminal (5a).
• Connect the twisted shield of the cable to the grounding terminal (5a).
• Connect the phase conductors of the cable to the L1, L2 and L3 terminals.
• Connect the phase conductors of the cable to the L1, L2 and L3 terminals.
5a
• Tighten the screws to the torque given below:
• Tighten the screws to the torque given below:
Frame size
Frame size
L1. L2. L3
6. Connect the braking resistor cable as the motor cable in step 4. L1, L2, L3
7. Ground the shield 360 degrees (6a).
6. Connect the braking resistor cable as the motor cable in step STEP_preparing_cables.
8. Connect the twisted shield to the grounding terminal (6b) and the conductors to
7. Ground the shield 360 degrees (6a).
the R+ and R- terminals (6c).
6c
5b
R0...R1
R0...R1
N·m lbf·ft
0.5...0.6 0.4
N·m lbf·ft
0.5...0.6 0.4
R2
R2
N·m lbf·ft
1.2...1.5 0.9...1.1
N·m
1.2...1.5
lbf·ft
0.9...1.1