ABB REB650 Manual page 60

Section 3
DNP3 protocol implementation
54
3.7 BINARY OUTPUTS Capabilities
AND BINARY OUTPUT (leave tick-boxes blank if
COMMANDS this data type is not
Binary Outputs Group supported)
Number: 10
Binary Output Events
Group Number: 11
Binary Output
Commands Group
Number: 12
Binary Output Command
Events Group Number:
13
● Always
○ Never
○ Only if the point is
assigned to a class
○ Based on point Index
(add column to table in
part 5)
3.7.4 Reports Output Command Event Objects:
● Never
○ Only upon a
successful Control
○ Upon all control
attempts
3.7.5 Static Variation reported when variation 0 requested or in response to Class polls:
● Variation 1 – packed
format
● Variation 2 – output
status with flags
○ Based on point Index
(add column to table in
part 5)
3.7.6 Event Variation reported when variation 0 requested or in response to Class polls:
Note: The support for binary output events can be determined remotely using protocol object Group 0
Variation 222.
○ Variation 1 – status
without time
○ Variation 2 – status
with time
○ Based on point Index
(add column to table in
part 5)
3.7.7 Command Event Variation reported when variation 0 requested or in response to Class polls:
Table continues on next page
Current Value If configurable, list
methods
Two PST or LHMI
(Obj10DefVar)
Not Supported
1MRK 511 419-UUS A
650 series 2.2 ANSI
Point list manual