ABB REB650 Manual page 15

1MRK 511 419-UUS A
650 series 2.2 ANSI
Point list manual
• Signals in frames with a shaded area on their right hand side represent
setting parameter signals that are only settable via the PST, ECT or LHMI.
• If an internal signal path cannot be drawn with a continuous line, the suffix -
int is added to the signal name to indicate where the signal starts and
continues.
• Signal paths that extend beyond the logic diagram and continue in another
diagram have the suffix "-cont."
• Dimensions are provided both in inches and millimeters. If it is not specifically
mentioned then the dimension is in millimeters.
Illustrations are used as an example and might show other products
than the one the manual describes. The example that is illustrated is still
valid.
Section 1
Introduction
9