Lenovo ThinkSystem SR650 Maintenance Manual page 209

2. Enable the Physical Presence Policy using either F1 (UEFI Settings) or Lenovo XClarity Essentials
OneCLI.
Assert Physical Presence through the Lenovo XClarity Controller
Complete the following steps to assert Physical Presence through the Lenovo XClarity Controller:
1. Log in to the Lenovo XClarity Controller interface.
For information about logging in to the Lenovo XClarity Controller, see:
http://sysmgt.lenovofiles.com/help/topic/com.lenovo.systems.management.xcc.doc/dw1lm_c_chapter2_
openingandusing.html
2. Click BMC Configuration ➙ Security and verify that Physical Presence is set to assert.
Assert Physical Presence through the hardware
You can also assert hardware Physical Presence through the use of a jumper on the system board. For more
information about asserting hardware Physical Presence through the use of a jumper, see:
"System board jumpers" on page 26
Set the TPM version
To set the TPM version, Physical Presence must be asserted.
For information about accessing the Lenovo XClarity Controller interface, see:
http://sysmgt.lenovofiles.com/help/topic/com.lenovo.systems.management.xcc.doc/dw1lm_c_chapter2_
openingandusing.html
To set the TPM version:
1. Download and install Lenovo XClarity Essentials OneCLI.
a. Go to http://datacentersupport.lenovo.com
b. Click Drivers & Software.
c. Navigate to the version of Lenovo XClarity Essentials OneCLI for your operating system and
download the package.
2. Run the following command to set the TPM version:
Note: You can change the TPM version from 1.2 to 2.0 and back again. However, you can toggle
between versions a maximum of 128 times.
To set the TPM version to version 2.0:
OneCli.exe config set TPMVersion.TPMVersion "Update to TPM2.0 compliant" -v --override --host <ip_address>
--user <userid> --password <password>
To set the TPM version to version 1.2:
OneCli.exe config set TPMVersion.TPMVersion "Update to TPM1.2 compliant" -v --override --host <ip_address>
--user <userid> --password <password>
where:
• <userid>:<password> are the credentials used to access the BMC (Lenovo XClarity Controller
interface) of your server. The default user ID is USERID, and the default password is PASSW0RD
(zero, not an uppercase o).
• <ip_address> is the IP address of the BMC.
For more information about the Lenovo XClarity Essentials OneCLI s s e e t t command, see:
http://sysmgt.lenovofiles.com/help/topic/toolsctr_cli_lenovo/onecli_r_set_command.html
3. Alternatively, you can use the following Advanced Settings Utility (ASU) commands:
and navigate to the support page for your server.
.
Chapter 3 Hardware replacement procedures
201