Lenovo ThinkSystem SR650 Maintenance Manual page 205

• Online from the target system, such as LAN or keyboard console style (KCS) access
• Remote access to the target system (LAN based)
Step 1. Copy and unpack the OneCLI package, which also includes other required files, to the solution.
Make sure that you unpack the OneCLI and the required files to the same directory.
Step 2. After you have OneCLI in place, use the following command syntax to set the UUID:
onecli config set SYSTEM_PROD_DATA.SysInfoUUID <uuid_value> [access_method]
Where:
<uuid_value>
Up to 16-byte hexadecimal value assigned by you.
[access_method]
The access method that you selected to use from the following methods:
• Online authenticated LAN access, type the command:
Example that does not use the user ID and password default values:
onecli config set SYSTEM_PROD_DATA.SYsInfoUUID <uuid_value> --user <user_id>
--password <password>
Example that uses the user ID and password default values:
onecli config set SYSTEM_PROD_DATA.SysInfoUUID <uuid_value>
• Online KCS access (unauthenticated and user restricted):
You do not need to specify a value for access_method when you use this access method.
Example:
onecli config set SYSTEM_PROD_DATA.SysInfoUUID <uuid_value>
Note: The KCS access method uses the IPMI/KCS interface, which requires that the IPMI
driver be installed.
• Remote LAN access, type the command:
Note: When using the remote LAN access method to access Lenovo XClarity Controller
using the LAN from a client, the host and the xcc_external_ip address are required
parameters.
[−−imm xcc_user_id:xcc_password@xcc_external_ip]
or
[−−bmc xcc_user_id:xcc_password@xcc_external_ip]
Where:
xcc_external_ip
The BMC/IMM/XCC external LAN IP address. There is no default value. This parameter
is required.
xcc_user_id
The BMC/IMM/XCC account name (1 of 12 accounts). The default value is USERID.
xcc_password
The BMC/IMM/XCC account password (1 of 12 accounts). The default value is
PASSW0RD (with a zero 0 not an O).
Note: BMC, IMM, or XCC external LAN IP address, account name, and password are all
valid for this command.
.
Chapter 3 Hardware replacement procedures
197