Install The Front I/O Assembly - Lenovo ThinkSystem SR650 Maintenance Manual

Install the front I/O assembly

Use this information to install the front I/O assembly.
Note: The following procedure is based on the scenario that you are installing the front I/O assembly for
server models with eight 3.5-inch drive bays. The installation procedure is similar for the front I/O assembly
for server models with eight or sixteen 2.5-inch drive bays.
For server models with twelve 3.5-inch drive bays or twenty-four 2.5-inch drive bays, the front I/O assembly
is assembled with the right rack latch. See "Install the rack latches" on page 99 for the installation
procedures.
Before installing the front I/O assembly, touch the static-protective package that contains the new front I/O
assembly to any unpainted surface on the outside of the server. Then, take the new front I/O assembly out of
the package and place it on a static-protective surface.
To install the front I/O assembly, complete the following steps:
Watch the procedure. A video of the installation process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-A25P7vBoGa_wn7D7XTgDS_
• Youku:
http://list.youku.com/albumlist/show/id_50483444
Figure 88. Front I/O assembly installation
Step 1. Insert the front I/O assembly into the assembly bay.
Step 2. Install the screws to secure the front I/O assembly in place.
After installing the front I/O assembly:
1. Connect the cables of the front I/O assembly to the system board. See "Front I/O assembly" on page 29.
2. Complete the parts replacement. See "Completing the parts replacement" on page 203.
.
Chapter 3 Hardware replacement procedures
119