Remove The Raid Adapter; Install The Raid Adapter - Lenovo ThinkSystem SR650 Maintenance Manual

Remove the RAID adapter

Use this information to remove the RAID adapter from the RAID adapter slot on the system board.
Note: The following procedure is based on the scenario that the RAID adapter is installed in the RAID
adapter slot on the system board. For the procedure about removing the RAID adapter from the PCIe slot,
see "Remove a PCIe adapter" on page 151.
Before removing the RAID adapter:
1. Remove the top cover. See "Remove the top cover" on page 103.
2. Remove any parts and disconnect any cables that might impede your access to the RAID adapter.
3. Record the cable connections on the RAID adapter and then disconnect all cables from the RAID
adapter. For information about the cable routing, see "Internal cable routing" on page 27.
To remove the RAID adapter from the RAID adapter slot on the system board, complete the following steps:
Watch the procedure. A video of the removal process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-A25P7vBoGa_wn7D7XTgDS_
• Youku:
http://list.youku.com/albumlist/show/id_50483444
Figure 103. RAID adapter removal
Step 1. Slide the left-side latch to the unlocked position.
Step 2. Push and hold the right-side latch in the direction as shown.
Step 3. Grasp the RAID adapter by its edges and carefully remove it from the RAID adapter slot on the
system board.
If you are instructed to return the old RAID adapter, follow all packaging instructions and use any packaging
materials that are provided.

Install the RAID adapter

Use this information to install the RAID adapter in the RAID adapter slot on the system board.
140
ThinkSystem SR650 Maintenance Manual