Serial Port Module Replacement; Remove The Serial Port Module - Lenovo ThinkSystem SR650 Maintenance Manual

2. Touch the static-protective package that contains the new LOM adapter to any unpainted surface on the
outside of the server. Then, take the new LOM adapter out of the package and place it on a static-
protective surface.
To install the LOM adapter, complete the following steps:
Watch the procedure. A video of the installation process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-A25P7vBoGa_wn7D7XTgDS_
• Youku: http://list.youku.com/albumlist/show/id_50483444
Figure 127. LOM adapter installation
Step 1. Place the LOM adapter into the connector at an angle.
Step 2. Rotate the LOM adapter down.
Step 3. Push the LOM adapter as shown to insert it into the connector on the system board.
Step 4. Tighten the thumbscrew to secure the LOM adapter.
Step 5. Align the mounting stud on the chassis with the hole in the LOM-adapter air baffle. Then, pinch the
tab 1 and lower the LOM-adapter air baffle onto the LOM adapter.
After installing the LOM adapter, complete the parts replacement. See "Completing the parts replacement"
on page 203.

Serial port module replacement

Use this information to remove and install the serial port module.
Note: The serial port module is available only on some models.

Remove the serial port module

Use this information to remove the serial port module.
Before removing the serial port module, remove the top cover. See "Remove the top cover" on page 103.
To remove the serial port module, complete the following steps:
164
ThinkSystem SR650 Maintenance Manual