Attaching An L-Shaped Label - Huawei DBS3900 Installation Manual

DBS3900 LampSite
Installation Guide
NE
l In the label, RHUB and pRRU identify the specific DBS3900 LampSite NEs.
l If only one RHUB is deployed, mark it as RHUB0 on the label. If multiple RHUBs are deployed, mark
l If only one pRRU is deployed, mark it as pRRU0 on the label. If multiple pRRUs are deployed, mark
l For details about the maximum number of RHUBs and pRRUs in the DBS3900 LampSite solution, see
Label Structure
Using the RHUB power label as an example,
LampSite engineering label.
Figure 11-1 Label structure

11.3 Attaching an L-Shaped Label

This section describes the procedure and precautions to be taken for attaching an L-shaped
label.
Issue 06 (2015-10-30)
Label Content
Antenna
label
NOTE
them in ascending sequence, beginning with RHUB0.
them in ascending sequence, beginning with pRRU0.
Typical Configurations in DBS3900 LampSite Technical Description.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Description
pRRUy Label for the pRRUy RF
Jumper.
ANTa
l y specifies the number
of pRRUs and cannot
exceed the maximum
pRRU number
supported by the
networking.
l a can be set to 0 to 5,
which respectively
correspond to ANT0
port and ANT5 port of
the pRRU.
Figure 11-1
Corresponding
port on the base
station
ANT0 to ANT5
shows the structure of a DBS3900
11 Appendix
172