Attaching An L-Shaped Label - Huawei DBS3900 Installation Manual

LampSite
Installation Guide
Figure 8-1 Label structure

8.3 Attaching an L-Shaped Label

This section describes the procedure and precautions to be taken for attaching an L-shaped label.
Context
l
l
l
Procedure
Step 1 Obtain the engineering label to be attached from the whole set of the L-shaped engineering labels,
as shown in
Figure 8-2 Engineering label to be attached
Step 2 Attach the long end of the engineering label to the cable in the position 20 mm away from the
connector, and then turn over the long end along the adhesive face. Ensure that the edges of the
turned-over engineering label are in a line, as shown in
Step 3 Adhere the long end to the labeling area. Ensure that the spacing between the cable and the
labeling area is 2 mm to 3 mm.
Issue 08 (2015-01-15)
This section applies to Huawei sign plate labels. If other engineering labels in accordance
with local standards are used on site, follow the local standards for attaching sign plate
labels.
In the LampSite solution, blank L-Shaped engineering labels are delivered by default.
The L-shaped label is usually used for the signal cable, E1/T1 cable, optical cable, and
power cable. The description in this section takes the Ethernet cable in a base station as an
example.
Figure 8-2.
NOTE
By default, the label is attached in the position 20 mm away from the connector. If required, you can change
the position to make installation faster and more efficient. Consistency and neatness, however, must be
maintained.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure 8-3.
8 Appendix
95