Huawei DBS3900 Installation Manual page 165

DBS3900 LampSite
Installation Guide
l
Procedure
Step 1 Connect the RJ45 connector at one end of the Ethernet cable to the PoE port on the
pRRU3902 panel, and push the cables into the cable clips.
Step 2 Optional: Connect the RJ45 connector at the other end of the Ethernet cable to the output
port of the Extender. Then, connect the RJ45 connector at one end of another Ethernet cable
to the input port of the Extender.
In this scenario, the Ethernet cable is divided into two parts, one between the RHUB and the
Extender and the other between the Extender and the pRRU3907.
Step 3 Connect the RJ45 connector at the other end of the Ethernet cable to any port ranging from
CPRI_E0 to CPRI_E7 on the RHUB panel based on the engineering design, as shown in
Figure
Figure 9-22 Installing an Ethernet cable
(1) Ethernet cable
Issue 06 (2015-10-30)
The Ethernet cable has the following functions:
– Provides power supply for the pRRU3907 when the cable connects the CPRI_E0
port on the pRRU3907 to the RHUB.
– Transmits CPRI signals between an RHUB and a pRRU3907.
9-22.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
(2) CPRI_E0 port on the pRRU3907
9 Installing a pRRU3907
159