Mitsubishi Electric MELSEC iQ-R Series Configuration Manual page 141

Installation procedure
■ Installing an 18-point screw terminal block
After installing the terminal block, tighten two terminal block mounting screws.
■ Installing a spring clamp terminal block
(1)
1.
Remove the protective cap from the Q6TE-18SN.
2.
Install the Q6TE-18SN to the module and tighten the
terminal block mounting screws. (tightening torque: 0.66
to 0.89Nm)
5 INSTALLATION AND WIRING
5.8 Mounting/Removing a Module or Terminal Block
5
139