Precautions For The Case Where An Rnencpu Is Set As Cpu No.1 - Mitsubishi Electric MELSEC iQ-R Series Configuration Manual

Precautions for the case where an RnENCPU is set as CPU No.1

When an RnENCPU is set as CPU No.1, set the module configuration diagram and the I/O assignment as shown below.
Module configuration diagram
Place the RnENCPU (network part)
*1 Set the RnENCPU as "_RJ71EN71()" in GX Works3.  in brackets indicates an abbreviation of network type.
For details, refer to the following.
 MELSEC iQ-R Ethernet/CC-Link IE User's Manual (Startup)
■ Configuration of two modules (CPU No.1: RnENCPU, No.2: Motion CPU)
• Actual system
• Module configuration diagram
■ Configuration of three modules (CPU No.1: RnENCPU, No.2 and No.3: Motion CPU)
• Actual system
• Module configuration diagram
1 SYSTEM CONFIGURATION
58
1.4 Precautions for System Configuration
*1
on the right of the Motion CPU at the rightmost position.
1.
Mount the RnENCPU (CPU part) on the CPU slot.
2.
Mount the Motion CPU on the slot 0.
3.
Mount the RnENCPU (network part) on the slot 1.
1.
Mount the RnENCPU (CPU part) on the CPU slot.
2.
Mount the Motion CPUs on the slot 0 and slot 1.
3.
Mount the RnENCPU (network part) on the slot 2.