Mitsubishi Electric MELSEC iQ-R Series Configuration Manual page 113

Fixing of the stopper
Fix the stopper to the DIN rail after the base unit installed the DIN rail adapter is mounted on the DIN rail.
(1)
(2)
(3)
When the base unit is mounted on the DIN rail, select the DIN rail in the light of the following dimensions of the
stopper.
For the dimensions (W) of the base unit, refer to the following.
Page 88 Performance Specifications of Base Unit
DIN rail
Unit: mm
The method for fixing the DIN rail stopper is an example. Fix the module in accordance with the manual for the
DIN rail stopper used.
Stopper
1.
Loosen the screw at the upper part of the
stopper (1).
2.
For the stopper fixed to the left side of the base
unit, turn up the arrow mark printed on the
stopper and hitch the tab (2) at the lower part of
the stopper to the DIN rail (3).
3.
Hitch the tab at the upper part of the stopper to
the upper part of the DIN rail.
4.
Fix the stopper on the right side of the base
unit upside down for the stopper of the left side.
5.
Slide the stopper to the end of the base unit.
6.
Tighten the screw of the stopper with a
screwdriver. (tightening torque: 1.00 to
1.35Nm)
7.
Check that both stoppers are fixed on the DIN
rail securely.
Base unit
W
W+18
5 INSTALLATION AND WIRING
5.4 Mounting Base Unit on the DIN Rail
Stopper
111
5