Mitsubishi Electric MELSEC iQ-R Series Configuration Manual page 138

■ Removal procedure (without a module fixing hook)
(1)
• The module surface temperature may be high immediately after power-off. When the module is removed,
pay attention to the burn injury.
• When removing the module, make sure that the module fixing screw is loosened up completely. Failure to
do so may damage the module.
• If the module fixing screw is broken, replace the case of the module. When replacing the case, please
consult your local Mitsubishi representative.
5 INSTALLATION AND WIRING
136
5.8 Mounting/Removing a Module or Terminal Block
(2)
(3)
1.
Loosen the module fixing screw (1).
2.
Pull the module toward supporting it at its
bottom.
3.
While lifting the module, remove the concave
part (2) from the guide (3) of the base unit.