Install The Raid Adapter - Lenovo thinksystem SR630 Maintenance Manual

Figure 86. RAID adapter removal
Step 1. Slide the left-side latch to the unlocked position.
Step 2. Push and hold the right-side latch in the direction as shown.
Step 3. Grasp the RAID adapter by its edges and carefully remove it from the RAID adapter slot on the
system board.
If you are instructed to return the old RAID adapter, follow all packaging instructions and use any packaging
materials that are provided.

Install the RAID adapter

Use this information to install the RAID adapter on the system board.
Note: The following procedure applies to RAID adapter installed on the system board. For the procedure
about installing the RAID adapter installed on the riser assembly, refer to "Install a PCIe adapter" on page 74.
Before installing the RAID adapter:
1. Touch the static-protective package that contains the new RAID adapter to any unpainted surface on
the outside of the server. Then, take the new RAID adapter out of the package and place it on a static-
protective surface.
2. If the new RAID adapter is installed with a bracket, remove the bracket.
To install the RAID adapter on the system board, complete the following steps:
Watch the procedure. A video of the installation process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-C_GGjNudxYy8-c69INMcmE
• Youku: http://list.youku.com/albumlist/show/id_50462008
96
ThinkSystem SR630 Maintenance Manual