Pcie Adapter Replacement - Lenovo thinksystem SR630 Maintenance Manual

Figure 57. Riser card installation
Step 2. Reinstall the PCIe adapters on the new riser card. See "Install a PCIe adapter" on page 74.
Step 3. Refer to your note to reconnect any cables to the PCIe adapters on the new riser card.
Step 4. Position the riser assembly on the chassis. Align the two pins on the bracket with the two holes in
the chassis and align the riser card with the riser slot on the system board. Then, carefully press the
riser assembly straight down into the slot until it is fully seated.
Figure 58. Riser assembly installation
After installing the riser card, complete the parts replacement. See "Complete the parts replacement" on
page 141.

PCIe adapter replacement

Use this information to remove and install a PCIe adapter.
The PCIe adapter can be an Ethernet adapter, a host bus adapter (HBA), a PCIe RAID adapter, a PCIe
interposer adapter, a PCIe solid-state drive, and any other supported PCIe adapters.
.
Chapter 3 Hardware replacement procedures
73