Rear Hot-Swap Drive Assembly Replacement; Remove The Rear Hot-Swap Drive Assembly - Lenovo thinksystem SR630 Maintenance Manual
Hide thumbs
Also See for thinksystem SR630:
- Maintenance manual (276 pages) ,
- Product manual (75 pages) ,
- Quick start (2 pages)
Table of Contents
Advertisement
• Youku:
http://list.youku.com/albumlist/show/id_50462008
Figure 79. TCM installation
Step 1.
Locate the TCM connector on the system board.
Step 2.
Insert the TCM into the TCM connector on the system board.
Note: Carefully handle the TCM by its edges.
After installing the TCM, complete the parts replacement. See "Complete the parts replacement" on page
141.
Rear hot-swap drive assembly replacement
Use this information to remove and install the rear hot-swap drive assembly.
Note: The term "hot-swap drive" refers to all the supported types of 2.5-inch hot-swap hard disk drives and
hot-swap solid-state drives.
Remove the rear hot-swap drive assembly
Use this information to remove the rear hot-swap drive assembly.
90
ThinkSystem SR630 Maintenance Manual
Advertisement
Table of Contents
