Remove The Rear Backplane - Lenovo thinksystem SR630 Maintenance Manual

Before installing the backplane, touch the static-protective package that contains the new backplane to any
unpainted surface on the outside of the server. Then, take the new backplane out of the package and place it
on a static-protective surface.
To install the backplane, complete the following steps:
Watch the procedure. A video of the installation process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-C_GGjNudxYy8-c69INMcmE
• Youku: http://list.youku.com/albumlist/show/id_50462008
Figure 70. Installation of backplane for ten 2.5-inch hot-swap drives
Step 1. Align the two pins on the backplane with the corresponding holes in the chassis as shown.
Step 2. Lower the backplane into the chassis. Ensure that the pins pass through the holes and the
backplane is fully seated in place.
After installing the backplane:
1. Connect the cables to the backplane. See "Server models with ten 2.5-inch drives" on page 33.
2. Reinstall all the drives and drive fillers into the drive bays. See "Install a hot-swap drive" on page 66.
3. Complete the parts replacement. See "Complete the parts replacement" on page 141.

Remove the rear backplane

Use this information to remove the rear backplane.
Before removing the rear backplane:
1. Remove the top cover. See "Remove the top cover" on page 42.
2. Remove the drives or drive fillers installed in the rear hot-swap drive assembly. See "Remove a hot-
swap drive" on page 65 and "Install a hot-swap drive" on page 66.
.
Chapter 3 Hardware replacement procedures
81