Install The Top Cover - Lenovo thinksystem SR630 Maintenance Manual

Step 2. Press the release button on the cover latch and then fully open the cover latch.
Step 3. Slide the top cover to the rear of the server until it is disengaged from the chassis. Then, lift the top
cover off the chassis and place it on a flat clean surface.
Attention:
• Handle the top cover carefully. Dropping the top cover with the cover latch open might damage
the cover latch.
• For proper cooling and airflow, install the top cover before you power on the server.

Install the top cover

Use this information to install the top cover.
Before installing the top cover:
1. Ensure that all cables, adapters, and other components are installed and seated correctly and that you
have not left loose tools or parts inside the server.
2. Ensure that all internal cables are correctly routed. See "Internal cable routing" on page 27.
3. If you are installing a new top cover, attach the service label to the new top cover first if necessary.
Note: A new top cover comes without a service label attached. If you need a service label, order it
together with the new top cover. The service label is free of charge.
To install the top cover, complete the following steps:
Watch the procedure. A video of the installation process is available:
• Youtube: https://www.youtube.com/playlist?list=PLYV5R7hVcs-C_GGjNudxYy8-c69INMcmE
• Youku:
http://list.youku.com/albumlist/show/id_50462008
.
Chapter 3 Hardware replacement procedures
43