Lenovo thinksystem SR630 Maintenance Manual page 12

Table 1. Server specifications (continued)
Specification
Internal drives
PCIe slots
Graphics processing unit
(GPU)
Input/Output (I/O) features
RAID adapters (depending on
the model)
4
ThinkSystem SR630 Maintenance Manual
Description
• Up to two M.2 drives
• Up to four 3.5-inch hot-swap SAS/SATA drives
• Up to eight 2.5-inch hot-swap SAS/SATA drives
• Up to ten 2.5-inch hot-swap SAS/SATA/NVMe drives (NVMe drives are supported
only in drive bays 6–9)
• Up to two 2.5-inch hot-swap SAS/SATA drives in the rear (only for server models
with 10 drive bays in the front; meanwhile, the processor TDP should be less than
or equal to 125 watt).
Notes:
– NVMe drives means Non-Volatile Memory express drives.
– For server models with rear hot-swap drive bays, NVMe drives are not
supported (both in the rear drive bays or in the front drive bays).
Depending on the model, your server supports up to three PCIe slots in the rear. For
detailed information, see "Rear view" on page 16.
• NVIDIA Quadro P2000 PCIe Active GPU
• Full-height, half-length PCIe adapter GPU
• TDP: 75 watt
Note: GPU is supported only when the following configuration requirements are met:
• Processor TDP is less than or equal to 140 watt.
• No RAID adapter is installed on the RAID adapter slot on the system board. If you
want to install a RAID adapter, install it in PCIe slot 1.
• The power of the hot-swap power supplies is 750 watt or 1100 watt.
• Front panel:
– One VGA connector (available on some models)
– One XClarity Controller USB connector
– One USB 3.0 connector
• Rear panel:
– One VGA connector
– Two USB 3.0 connectors
– One XClarity Controller network connector
– Two or four Ethernet connectors on the LOM adapter (available on some
models)
– One serial port (available on some models)
• A RAID 530-8i SAS/SATA adapter that supports JBOD mode and RAID levels 0, 1,
5, 10, and 50
• A RAID 730-8i SAS/SATA adapter that supports JBOD mode and RAID levels 0, 1,
5, 10, and 50 (only available in China)
• A RAID 930-8i or 930-16i SAS/SATA adapter that supports JBOD mode and RAID
levels 0, 1, 5, 6, 10, 50, and 60
• A RAID 930-8e SAS/SATA adapter that supports JBOD mode and RAID levels 0,
1, 5, 6, 10, 50, and 60