Commands - GE F650 User Manual

CHAPTER 3: INTERFACES, SETTINGS & ACTUAL VALUES
Once this sequence is completed, these values remain stored in the relay, and the display once again shows the date at
the bottom of the text screen.

3.2.6.9 Commands

Commands are configured using EnerVista 650 Setup, and they can be executed using the pushbuttons on the relay front.
Use the EnerVista 650 Setup software to configure up to 24 commands with a descriptive text. When executing the
operations from the relay front panel, the operation description is displayed.
Example of commands (operations) executions via HMI
GEK-113000-AF
Figure 3-27: Change date & time in HMI
Press the enter/shuttle key when Commands is selected in the display (o).
All the previously configured commands are displayed. Press up-down keys or
rotate the shuttle key to move through the available commands. Press ESC to
return to previous level.
Press the enter/shuttle key to pre-select the operation to execute.
When the message Push Enter for Confirmation appears, press the enter/shuttle
key to confirm.
Once the command has been performed or the time out has expired the Command
completed message is shown on the display.
Figure 3-28: Commands in HMI
F650 DIGITAL BAY CONTROLLER
3.2 HUMAN-MACHINE INTERFACE (HMI)
3-53