Hitachi Compute Blade 500 Series Web Console Users Manual page 173

Item
Power rating of
chassis
Power capping DCMI mode
Accurate power
control value (APC)
(Setting)
Emergency power
control value (EPC)
Control status
(APC)
Control status
(EPC)
Power supply module redundancy
Power supply module optimization
Power equipment Enable/Disable
environment
Rated current of
circuit breaker
Number of circuit
breaker
Rated current of
PDU
Number of PDU
Operating the Web Console
Hitachi Compute Blade 500 Series Web Console User's Guide
Description
Shows the total rated power of modules in the
server chassis.
Shows the condition of DCMI mode.Action
combo box on the upper right. Enable/disable
the DCMI mode from Action menu.
Shows the APC (accurate power control) power
capping value in operation.
Nothing is shown if DCMI mode enabled.
Shows the EPC (emergency power control)
power capping value for protecting the
equipment.
Shows whether or not the performance is
limited due to exceeding the APC setting value.
Shows whether or not the performance is
limited due to exceeding EPC.
Nothing is shown if DCMI mode enabled.
Shows the power supply module redundancy.
One of the following is shown depending on the
equipment power voltage:
100VAC: N+N, N+1, N+0
200VAC – 240VAC: N+N, N+1
Enables or Disables power supply module
optimization.
Shows the power equipment environment
setting to EPC is either Enable no Disable.
Sets the rated current of a fuse free breaker
(FFB).
100VAC: 10A – 100A (default value: 15A)
200VAC – 240VAC: 15A – 100A
With the number of PDU 0, default value is 15A.
With the number of PDU 1, default value is 30A.
Sets the number of fuse free breakers (FFB):
1/2/3/4:
With N+N, default value is 2.
With N+1, default value is 1.
With N+0, default value is 1.
Sets the PDU rated current.
100VAC: Not supported.
200VAC – 240VAC: 15A – 100A (default value:
24A)
Sets the number of PDUs: 0/1/2
With N+N, default value is 2.
With N+1, default value is 1.
2-163