Hitachi Compute Blade 500 Series Web Console Users Manual page 105

Item
Notes:
1 Shows the server blade status.
.
2 Shows the server blade settings.
.
3 Shows the ServerConductor/Blade Server Manager (BSM) communication
.
settings only when the server blade is powered on.
Note:
• If 129 or larger value is set to VNIC System number, the displayed
value varies depending on the condition as follows:
- When the server blade is powered off: The currently set value is
shown.
- When the server blade is powered on with management module
firmware version A0135 or earlier: The value 255 is shown.
- When the server blade is powered on with management module
firmware version A0145 or later: The currently set value is shown.
• To show the value of VNIC System No. 129 or larger correctly, use
management module firmware version A0145 or later regardless of
the server blade power state.
Tip: In SMP configuration, settings for the primary server blade are
applied. If a non-primary server blade is selected, the settings are shown
but LPAR manager will not operate with those setting values.
Table 2-99 Action button at the bottom
Item
Assign firmware to Assign LPAR manager firmware to the server blade. Shows the
Server Blade Assign firmware to Server Blade (Selecting LPAR manager F/W
version) dialog box.
Change LP model Assign LPAR manager model to the server blade. Shows the
Change LP Model dialog box. This button is not available when
the server blade is running.
Edit settings Change LPAR manager settings. Shows the LP Settings (Editing)
dialog box.
Save settings Save LPAR manager configuration.
Close Close the LP Setting dialog box.
Operating the Web Console
Hitachi Compute Blade 500 Series Web Console User's Guide
Description
Description
2-95