Hitachi Compute Blade 500 Series Web Console Users Manual page 112

Note: The values of following items cannot be set/changed while an LPAR
manager is running.
•
•
•
•
In addition, use HVM Navigator or LPAR manager screen to set the items
which are not supported by web console.
Tip: [Management module firmware version A0180 or later]
When LPAR manager address is set to 0.0.0.0, subnet mask and default
gateway will be also set to 0.0.0.0. LPAR manager is not available when
LPAR manager address is set to 0.0.0.0.
Tip: In SMP configuration, settings for the primary server blade are
applied. If a non-primary server blade is selected, the settings are shown
but LPAR manager will not operate with those setting values.
Logical
Partitioning
IP Address text box
2-102
Logical Partitioning
IP Address
Subnet Mask
Default Gateway
Table 2-110 Items in LP Settings (Editing)
Item
Enabled radio
button
Disabled radio
button
Operating the Web Console
Hitachi Compute Blade 500 Series Web Console User's Guide
Description
Sets Logical Partitioning enable.
Sets Logical Partitioning disable.
Sets IPv4 address used by LPAR manager.
The format of IPv4 is (xxx.xxx.xxx.xxx).
(xxx: a figure between 0 and 255)